Academic Integrity: tutoring, explanations, and feedback — we don’t complete graded work or submit on a student’s behalf.

Figure 1 shows top view, front view and side view of 50 mm ×30 mm × 15 mm thick

ID: 2327420 • Letter: F

Question

Figure 1 shows top view, front view and side view of 50 mm ×30 mm × 15 mm thick plate with a pattern if three 8 mm H7 tapped holes as shown.

A) Using the length, width and thickness of the plate as the basic dimensions, show the dimensions appropriately on the drawing
B) Show the location of the holes if they the t holes are equally spaced; the holes close sides are to be located at 15 mm from the edges.
C) Using the bottom surface as datum A, show the flatness tolerance on datum A to be 1/10 mm.
D) Use C as the secondary datum and show a perpendicularity tolerance as one half of one mm.
E) Use B as the tertiary datum and indicate its perpendicularity tolerance of 0.3 mm with reference to primary and secondary datums
F) Show the positional tolerance and tolerance of the three holes by a suitable feature control frame.

O O O I II I II

Explanation / Answer

Answer of the following question is as follows.

The location of the hole is20cm left hand side .

The value of tolerance is 30 micron .

Related Questions

Figure 1 Figure 2 Consider two separate systems, each with four charges of magni
Question #1954242
Figure 1 Figure 2 Figure 3 Figure 4 A concave lens refracts parallel rays in suc
Question #1571325
Figure 1 Figure 2 Figure 3 l. In the series circuit as shown in Figure 1, if the
Question #1436820
Figure 1 Figure 2 tq -q -q 1q +q 6. [Ipt Consider two separate systems, each wit
Question #1577181
Figure 1 Figure 2 tq -q -q 1q +q 6. [Ipt Consider two separate systems, each wit
Question #1869770
Figure 1 Instructions In this case, you will create a Visual Basic solution that
Question #659024
Figure 1 Kirchhoff\'s Rules: rcuit shown in figure 2 (resistors in series). Sugg
Question #2030691
Figure 1 Kirchhoffs Rules: 2. Set up the circuit shown in figure 2 (resistors i
Question #2030817
Hire Me For All Your Tutoring Needs
Integrity-first tutoring: clear explanations, guidance, and feedback.
Drop an Email at
drjack9650@gmail.com
Chat Now And Get Quote

Navigate

Previous
Figure 1 shows the velocity-versus-time graph for a basketball player traveling
Next
Figure 1 uestion 6 fr 6 ft Question (2) (20%) Figure 2 below shows a front view

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.