Based on your knowledge of TTL implementation, why did the ICs need to be powere

Question

Based on your knowledge of TTL implementation, why did the ICs need to be powered with +5V and GND? g: 2 Select one: 1.00 a. TTL implementation utilizes computer memory to store truth tables. The power was required to power these memory modules b. The ICs each contain a small computer that requires power, but the gates themselves can operate without power. The computer is used to increase the speed and stability of the entire system. c. TTL implementation utilizes transistors as switches that connect the output to either power rail based on the inputs. For example, a logic HIGH occurs when the output is connected to the +5V power rail through the internal transistors. stion O d. Actually, it wasn't necessary in this lab. Check When prototyping a circuit on a breadboard you should (select all that apply): aining: 2 t of 1.00 question Select one or more: a. connect wires to every hole on the board. b. use red wires for power lines and black wires for ground lines. c. create easier access to the power rails by connecting the power supply to the holes along either edge that run the length of the breadboard d, place ICs so they straddle the trough. Check o 5 A 2-input gate that outputs a logic HIGH when its inputs are equal is a: emaining2 s out of 1.00 lag question Select one: a.AND gate. b. XNOR gate. c. XOR gate. d. OR gate. 0

Explanation / Answer

Answer :- 3) Option c is the correct answer.

Answer :- 4) For breadboard connection, option b and option c are matching correctly. Connection of wire to every hole is not necessary, only required pins are to be connected. And we should place the IC so that each pin of IC will get separate hole.

Answer :- 5) 2 -input XNOR gate output is always high when the inputs are same. So option b is the correct answer.

Related Questions

Navigate

• Browse (All)
• Browse B
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.