the heater, with a sectional view cut directly down the middle of the heating el
ID: 2996603 • Letter: T
Question
the heater, with a sectional view cut directly down the middle of the heating element input lines. The isometric view shows the three holes on the top for feeds and outlets. The leftmost hole is the inlet from well, the middle is steam release (if the water heater were to get too pressurized, steam is released through here after a meltdown heating). The right most hole is the outlet, where hot water is fed into the housing pipe systems. Two large cut insulation sections and holes exist on the side, where electrical heater can be placed in side to heat the water. There is a drain hole at the bottom.
Material
Thickness (in)
Steel tank (AISI C1020 Hot Rolled)
0.078
Polystyrene Insulation
1.5
Steel shell (AISI 304 Sheet Metal)
0.022
Material
Thickness (in)
Steel tank (AISI C1020 Hot Rolled)
0.078
Polystyrene Insulation
1.5
Steel shell (AISI 304 Sheet Metal)
0.022
Explanation / Answer
Question have not understand perfectly
Related Questions
Navigate
Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.