on points) Measurement Tools should be checked against a periodically to verify

Question

on points) Measurement Tools should be checked against a periodically to verify accuracy O Each Other a Standard O ruler O visual Save Question 2 (2 points) In class we discussed the fact that it is a very bad practice to directly plunge end mills (treat them like drill bits) and there are three common approaches to avoid situation, they are: O A) Conventional, Climb, and start off of the part B) Start off of the part, Ramp in, or utilize a pilot hole O C) Center cutting end mill, conventional, climb mil O D) Side cut, End Mill, Bore

Explanation / Answer

1. Standard.

A standard of any measurement is ,ade up of different material which does not change its properties or measurement overtime or due to ecternal conditions. Hence its property remans unchanged and is used to calibrate other devices.

2. Option B. End mills are different from drilll bits and they are used as drill bits by using them for Start offf the part, Ramp in and by utilizinf a pilot hole.

Related Questions

Navigate

• Browse (All)
• Browse O
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.