List your inputs on the following settings of the waveform generator and oscillo

Question

List your inputs on the following settings of the waveform generator and oscilloscope in order to output and display a 10 kHz sine wave with a maximum value V max = +2 V and a minimum value V min = 0V. Waveform generator Waveform: Frequency: Amplitude Vpp: Offset: Channel Load "impedance": Set to 50 ohm OR Set to High Z Oscilloscope Vertical scale, V/div: Horizontal scale, time/div: Trigger level: The power supply is set to a voltage limit of 20 V and a current limit of 0.1 A. The multimeter is configured to measure the output current of the power supply. The outputs are connected to a variable load resistor. Answer the following questions. Using the pictures below, draw in the required connections between the power supply, multimeter and the load (draw the load as a two terminal resistor). The resulting current measurement should show positive current.

Explanation / Answer

1) a)

waveform -- sine

frequency -- 10KHz

Amplitude--2Vp-p

offset -- 1Vp-p

channel load impedance -- 50 ohm

b)

vertical scale -- 1Vp-p

horizontal scale --50 micro sec /div

trigger level--maximum

2) a)

Related Questions

Navigate

• Browse (All)
• Browse L
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.