Which of the following dimensions is closest to being correct for clutch pedal f

Question

Which of the following dimensions is closest to being correct for clutch pedal free play measured at the pedal? 1/2 inch (12 mm) 11/2 inches (38 mm) 2 inches (50 mm) 21/2 inches (62 mm) Which of the following dimensions is closest to being correct for clutch brake squeeze? 1 inch (25 mm) 1/2 Vt inches (38 mm) 2 inches (50 mm) 21/2 inches (62 mm) Which of the following could cause clutch hang-up? seized pilot bearing cocked intermediate drive plate pins seized throwout bearing stretched clutch linkage rod Which of the following driving techniques can causo glazed clutch friction faces? starting off in high gear riding the clutch pedal holding the truck on an incline with the clutch pedal all of the above What is the function of coaxial springs in a clutch friction plate? dampens driveline torsionals dampens engine torsionals reduces clutch chatter all of the above Which of the following is more likely to cause the spline tangs to shear in a clutch brake? clutch brake squeeze below specification excessive free pedal setting attempting to brake the truck with the clutch brake riding the clutch pedal If a pot-type clutch has the flywheel face machined, what else must also be machined? flywheel pot flange pilot bearing bore intermediate plate drive lugs ring gear

Explanation / Answer

4. (b) 1.5 inches

The amount of distance of the clutch pedal from the fully released position to the fully pressed position is called 'clutch pedal free play'. It varies from 0.50 in to 1.75 inch.

5. (a) 1 inch(25mm)

The correct clutch brake squeeze is around 1 inch.

6. (a),(b),(c),(d)

There are many reasons for clutch to hang up. All the four options may cause the clutch to hang up.

7. (d)

Starting in high gear, Riding the clutch plate, holding the truck on an incline , all lead to frictional faces to be glazed.

8. (d)

The coaxial spring in a clutch friction plate dampens driveline torsionals as well as engine torsionals and reduces clutch chatter.

9. (c)

When there is an attempt to brake the truck with clutch brake , there is shearing in the spline tangs in a clutch brake.

10. (a)

Flywheel pot flange must also be flanged so that flywheel can be installed on it.

Related Questions

Navigate

• Browse (All)
• Browse W
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.