1. (TCO 4) The dynamic updating of a routing table is done by _____. (Points : 2

Question

1. (TCO 4) The dynamic updating of a routing table is done by _____. (Points : 2)        a routing protocol
       a static route
       the spanning tree protocol
       All of the above Question 2.2. (TCO 4) To show the OSPF process ID you would enter what command? (Points : 2)        show route table
       show process ID
       show ip OSPF
       process ID display Question 3.3. (TCO 4) How does the BDR know that the DR has failed? (Points : 2)        The DR stops sending Hello packets.
       The DR stops sending keep alive frames.
       The BDR asks the DR each minute.
       The hop count increases. Question 4.4. (TCO 4) What is a requirement of the reference bandwidth in OSPFv3? (Points : 2)        It prevents the router from automatically adjusting the bandwidth.
       It should be the same on all routers in the domain.
       It is set to 1 Gb/s by default.
       It increases the speed of the link. Question 5.5. (TCO 4) Why might you use the ip ospf priority command with OSPF? (Points : 2)        To provide a back door for connectivity during the convergence process
       To influence the DR/BDR election process
       To streamline and speed the convergence process
       To activate the OSPF neighboring process Question 6.6. (TCO 4) The OSPF hello and dead intervals are configurable per _____. (Points : 2)        OSPF process
       ip protocol
       interface
       router Question 7.7. (TCO 4) To force a router priority change to take effect on a router, this command can be used. (Points : 2)        clear ip ospf process
       clear priority
       reset dr
       reenable router process Question 8.8. (TCO 4) To propagate a default route configured with OSPF, the _____ command is used.(Points : 2)        ip route
       redistribute routes
       default-information originate
       inner route 1. (TCO 4) The dynamic updating of a routing table is done by _____. (Points : 2)        a routing protocol
       a static route
       the spanning tree protocol
       All of the above

Explanation / Answer

Q1.) The dynamic updating of a routing table is done by routing protocol. Hence option a is correct.

Q2.) To show the OSPF process ID "show ip OSPF" is used. Hence option c is correct.

Q6.)  The OSPF hello and dead intervals are configurable per interface. Hence option c is correct.

Q8.) To propagate a default route configured with OSPF, the default-information originate command is used. Hence option c is correct.

Related Questions

Navigate

• Browse (All)
• Browse 1
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.