Basie Electricity 012-04367E Experiment 7: Kirchhoff\'s Rules EQUIPMENT NEEDED:

Question

Basie Electricity 012-04367E Experiment 7: Kirchhoff's Rules EQUIPMENT NEEDED: -Two D-cell Batteries -Circuits Experiment Board Wire Leads Resistors -Digital Multimeter (DMM) Purpose The purpose of this lab will be to experimentally demonstrate Kirchhoff' s Rules for electrical circuits. Procedure Connect the circuit shown in Figure 7.1 a using any of the resistors you have except the 10 one. Use Figure 7.1b as a reference along with 7.1a as you record your data. Record the resistance values in the table below. With no current flowing (the battery disconnected), mea- sure the total resistance of the circuit between points A and B. R, C Wire Wire D R Figure 7.1a Figure 7.1b With the circuit connected to the battery and the current flowing, measure the voltage across each of the resistors and record the values in the table below. On the circuit diagram in Figure 7.lb, indicate which side of each of the resistors is positive relative to the other end by placing a"+"at that end. Now measure the current through each of the resistors. Interrupt the circuit and place the DMM in series to obtain your reading. Make sure you record each of the individual currents, as well as the current flow into or out of the main part of the circuit, I,

Explanation / Answer

We will use V=IR,

According to the values you have mentioned in the table, I am filling the rest of the values just as you asked.

V1=2.604 V

V2=0.8712 V

V3=48.081 V

V4=0.049 V

V5=16.50 V

Related Questions

Navigate

• Browse (All)
• Browse B
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.