A measurement system has a signal component at 15 kHz and a noise component at 6

Question

A measurement system has a signal component at 15 kHz and a noise component at 60 Hz. What type of filter would you use to improve your measurements? Filter Type__ Given the requirement of at least 0.995 VV of pass band gain at 15 kHz, specify your filter's key frequencies (provide appropriate terms for the filter type you selected above ie., fo, Q, BW, etc.) Draw a circuit diagram of your filter. Show numerical values for all components (R, L, C's). If you were given the alternative requirement of at least 40 dB of attenuation at 60 Hz, specify your filter's key frequencies (provide appropriate terms for the filter type you selected above ie., fc, f, , fo Q, BW, etc.)

Explanation / Answer

According to chegg policy, i have to answer only 1st question.

1)As we have to allow signal of 15khz (high frequency signal) and we have to block the noise (60 hz which is of low frequnecy) ,so we have to use high pass filter .It will block the lower frequency and allow the high frequnecy to pass

Related Questions

Navigate

• Browse (All)
• Browse A
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.