This practice exercise should challenge you. F of this part, use radius values,

Question

This practice exercise should challenge you. F of this part, use radius values, not angles. Save this CAT Part as ' Lesson i Exercise 3.CATPart." This part can be done using the radius option in the Profile command. Before starting, set the grid Primary Spacing to 1 and the Graduations to 4. Start at the bottom left comer of the pan. Select the Profile icon from the right menu bar. Sketch the vertical 1.50-inch line that defines the left edge of the part. Now sketch the first are along the top of the part. To do this, hold down the left mouse button and drag it in the direction you want the are to go then release the mouse button. The are will appear and allow you to drag and place it where you want. Place it on the and intersection 2 inches above the bottom of the part and a half inch to the right. This will only create half of the are needed, so the process will have to be repeated to sketch the other half of the are. Finish sketching the rest of the part. When you reach the inside .25 radius, repeat Step 4. When the sketch is done constrain it to double check that all of the dimensions match the part shown above. Make changes if necessary.

Explanation / Answer

follow the below link and click on "view raw" to download

https://github.com/jai0981996/helloworld/blob/master/lesson%203%20exercise%203/lesson_3_exercise_3.CATPart

all dimensions in the file is in inches

Related Questions

Navigate

• Browse (All)
• Browse T
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.