Manual transmissions usually cotai (A) reverse idler shaft (B) input shaft (C) t

Question

Manual transmissions usually cotai (A) reverse idler shaft (B) input shaft (C) turbine shaft (D) reverse idler shaft (E) output shaft. 8.- n all of the following.escspt 9. The input shaft gear and cluster drive gear in a manual transmission are in constant mesh while in (A) any forward gear (B) reverse (C) neutral (D) all of these An automatic transmission will usually contain all of the following.except (A) an integral differential assembly (B) one or more planetary gear sets (C) holding bands and multiple dise clutches (D) hydraulic control valves. 10. A metal drive belt and variable diameter pulleys are used in (A) all vehicles with longitudinal engine and a manual transaxle (B) a duel clutch transmission (C) a continuously variable transmission (D) 6 speed automatic transmissions. 12.--which of the following is turned directly by the engine crankshaft? (A) impeller 12(B) stator 13.---which of the following is used to turn a hydraulic coupling into a torque converter? 3.(A) impe 4 (B) stator (C) turbine (D) none of these (A) impeller (B) stator (C) turbine (D) none of these. 14.- Maximum torque multiplication is delivered when the impeller has reached its highest velocity and (A) the converter coupling point has been reached (B) the lockup clutch is engaged (C) the turbine is at stall (D) all of these. highest If the ring gear in a planetary gearset is held, then when the planet carrier is driven the sun gear moves (A) faster than the planet carrier (B) slower than the planet carrier (C) at the same speed but opposite direction of the planet carrier (D) none of these. 15. A transmission band usually (A) has one end secured to the transmission case (B) has one end secured to a servo (C) is used to stop the rotation of a clutch drum (D) all of these. 16, The automatic transaxle shown on textbook page 375 shows (A) four clutch packs and an overrunning clutch (B) a lockup torque converter (C) an integral differential assembly connected to the final driven gear (D) all of these. 18,-- The fluid flowing through the transmission cooler comes directly from the (A) fluid filter (B) torque converter (C) accumulator (D) fluid pump. (A) flu The ECU on a newer vehicle may control all of the following except the (A) torque converter clutch solenoid (B) shift valves (C) governor valve 19, 9(A) torg (D) line pressure.

Explanation / Answer

8=C

9=C

10=D

11=C

12=A

13=C

14=D

15=A

16=D

17=D

18=D

19=D

Related Questions

Navigate

• Browse (All)
• Browse M
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.