Hard to read the cursive handwriting, would be helpful if you could type it out

Question

Hard to read the cursive handwriting, would be helpful if you could type it out on the computer and number them so I know where you are at. thank you.

ECT 122 Week 3 iLab #1

4. Download the Multisim file “Series1” from Doc Sharing, Week 3. Run the simulation and verify the simulated results are the same as the calculated values. Were the values the same? Yes/No. If No, why?

Simulated:

XMM1 = = __________ (Total resistance)

5. Construct the circuit above on the breadboard. Have the professor verify the circuit. Using the handheld DMM and ELVIS DMM (if you are using ELVIS), measure each resistor value and the total resistance. Record the values in the table below. Compare the measurements and verify that they are within acceptable range.

Component

Rated Value

Hand Held DMM Measured Resistance

ELVIS DMM Measured Resistance (if applicable)

R1

1kW

R2

3.3kW

R3

2.2 kW

RT

Table 1

Component

Rated Value

Hand Held DMM Measured Resistance

ELVIS DMM Measured Resistance (if applicable)

R1

1kW

R2

3.3kW

R3

2.2 kW

RT

Explanation / Answer

4)All resitance are connected in sereies so

RT=1k+3.3k+2.2k=6.5kW

in your screenshot its not simulated, kindly check the simulation it must be 6.5k ohm

also ur breadboard result must be around 6.6k ohm

Related Questions

Navigate

• Browse (All)
• Browse H
• Subjects

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.