2 On this recording of a finger pulse, you cannot see mv the tops of the peaks b

Question

2 On this recording of a finger pulse, you cannot see mv the tops of the peaks because they were cut off at the range limit. a. Could you measure the amplitude of the peaks from this recording? (I pt) b. Is there any way to recover the data without re-recording the finger pulse? (I pt) c. What would you adjust and in what direction to re-record this and see the peaks? (2 pts). Time 3. Assume that you have opened the stimulator panel so that you can control when the stimulus occurs to the frog leg muscle that you are working with. The stimulator panel that comes up is below. a) What is the amplitude of the stimulus in mV? b) What is the frequency at which pulses will be delivered when you click stimulate (I pt) (I pt) Stimulator Document Output: Puse Max Repeat Rate Pulse Height Pulse Width 01s

Explanation / Answer

2) a) Yes amplitude of the peak can be measured from this recording by removing the low frequency artifacts using filters.

3)

a) Amplitude of the peak can be determined from this recording,

1V= 1000mV

9V= 9*1000= 9000mV

B)The frequency with which the pulses are delivered is 6. Since maximum repeat rate is 6, thus after every 6 times it will be repeated.

Related Questions

Navigate

• Browse (All)
• Browse 2
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.