Print graph page #1 (similar to figs.3) as a part of your lab report on experime

Question

Print graph page #1 (similar to figs.3) as a part of your lab report on experiment 5. click on "file" at the top-left "corner, in the pop-up select "print page setup" and "landscape", then print it out. Let your TA check your graph page1 #1. if OK, your TA will sign it. caution: make sure that your printed page #1, is OK before you close the capstone. all the collected in experiment 5 will be lost when the capstone is closed! close PASCO capstone by clicking the red-cross at the upper corner, then select "discard". turn off PASCO 850 interface and shut down the computer. clean up your bench. your lab report should be in the required format described in the "introduction" of the lab manual. graph page #1 (similar to fig. 3) should be included in your lab report. table A should be included in your lab report. it is required that the answers to the questions (see below) should be included in your lab report. you may tear the pages out of the lab manual, which contain your data tables and your answers to the listed questions. use these pages as a part of your lab report. what are the units of the fitting parameters m and b? draw a conclusion from comparison of measurement #1 with measurement #3 in table A. draw a conclusion from comparison of measurements #2, #3 and #4 in table A.

Explanation / Answer

1)   Unit of parameter m =   m/sec2

       Unit of parameter b =   kg.m/sec

2) Comparison shows that measurement 1 and measurement 3   shows a very wide range of deviation .

3)    Comparison shows that measurement 2 , measurement 3 and measurement 4 shows a very small amount of difference , or the values are very close .

Related Questions

Navigate

• Browse (All)
• Browse P
• Subjects

---

---

Integrity-first tutoring: explanations and feedback only — we do not complete graded work. Learn more.